You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have installed Octo4A on a MiniX Neo X7 with Android 4.4.2 connected to a monitor and a Creality CR-10S Pro V2 with Github Firmware 7.4.6 Based on Tiny Machines Fw. Everything is connected and is looking OK. Print starts but after the first few layers the Octo4A blinks on the monitor and a new IP-adress appears and the print stops. Any suggestions on what is wrong?
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
I have installed Octo4A on a MiniX Neo X7 with Android 4.4.2 connected to a monitor and a Creality CR-10S Pro V2 with Github Firmware 7.4.6 Based on Tiny Machines Fw. Everything is connected and is looking OK. Print starts but after the first few layers the Octo4A blinks on the monitor and a new IP-adress appears and the print stops. Any suggestions on what is wrong?
Beta Was this translation helpful? Give feedback.
All reactions