You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Adding an IP address on an interface that is not cabled should not trigger addition of flow table entries. Only after the port is UP, should there be flows in tables 10, 20 and 30.
Flow table entries in Tables 20 and 30 should disappear when the port is set down.
Flow table entries in Table 10 should be removed once an interface is set down.
Actual Behavior
Adding an IP address on an interface where link or admin state is down triggers the creation of flow table entries in Table 10, 20 and 30.
Removing the IP address (regardless of state UP or DOWN) correctly removes flows in tables 20 and 30. Table 10 entries are still present.
Setting an interface from up to down does not delete flow entries for the port in table 10, 20 and 30.
Steps to Reproduce the Problem
Pick a port, say port 2, which has a cable connected. Set interface down on both server side and switch side. (ip link set port2 down). Start with clean switch, reboot if necessary. The command 'client_flowtable_dump' should only show entries in Table 60.
Add an IP to the port on the switch side:
ip a a 10.0.0.1/24 dev port2
Check flow entries in table 10, 20 and 30 with client_flowtable_dump. Flows should not be there.
Remove IP on the switch side:
ip a del 10.0.0.1/24 dev port2
Check flow entries in table 10, 20 and 30 with client_flowtable_dump. Entries from table 20 and 30 are deleted, but table 10 still remains.
Specifications
Version: baseboxd 1.5.0
Platform: tested on both agema-ag7648 and accton-as4610
Subsystem:
The text was updated successfully, but these errors were encountered:
Expected Behavior
Actual Behavior
Steps to Reproduce the Problem
Pick a port, say port 2, which has a cable connected. Set interface down on both server side and switch side. (ip link set port2 down). Start with clean switch, reboot if necessary. The command 'client_flowtable_dump' should only show entries in Table 60.
Add an IP to the port on the switch side:
ip a a 10.0.0.1/24 dev port2
Check flow entries in table 10, 20 and 30 with client_flowtable_dump. Flows should not be there.
Remove IP on the switch side:
ip a del 10.0.0.1/24 dev port2
Check flow entries in table 10, 20 and 30 with client_flowtable_dump. Entries from table 20 and 30 are deleted, but table 10 still remains.
Specifications
The text was updated successfully, but these errors were encountered: