You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm trying to add line numbers to tool-change commands in an Okuma file, but GCode-Syntax doesn't recognize the G116 code that Okuma uses for tool changes, so nothing happens. Thanks!
The text was updated successfully, but these errors were encountered:
Sorry for taking so long to get back on here and address this. The only issue is that it falls within a G110-G129 for alternate coordinate systems. I can either make a checkbox flag in the options to allow that or incorporate it into the machine type selections.
I'm trying to add line numbers to tool-change commands in an Okuma file, but GCode-Syntax doesn't recognize the G116 code that Okuma uses for tool changes, so nothing happens. Thanks!
The text was updated successfully, but these errors were encountered: