You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
See page Lolin S3 PRO.,
section: Install, Repair, or Update UF2 Bootloader.
Note that Button 0 standard is not connected to GND.
My experience is: connect pin 0 (which is connected to Button 0) to pin GND, then perform the button presses as instructed in this section. After the board is in the bootloader mode one can undo the connection between pin 0 and pin GND.
The text was updated successfully, but these errors were encountered:
See page Lolin S3 PRO.,
section:
Install, Repair, or Update UF2 Bootloader
.Note that
Button 0
standard is not connected to GND.My experience is: connect
pin 0
(which is connected toButton 0
) topin GND
, then perform the button presses as instructed in this section. After the board is in the bootloader mode one can undo the connection betweenpin 0
andpin GND
.The text was updated successfully, but these errors were encountered: