You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When using support BLOCKERS and auto support with SNUG it puts support in small areas. e.g I make small cylinder holes in my prints with diameter 2.3 or 3.3 mm and despite support blocker the slicer ignores it. And it is not only this files attached it does it.
Actual results
Soppuer are printed in places where it is not supposed to be printed
Is there an existing issue for this problem?
OrcaSlicer Version
2.0.0
Operating System (OS)
Windows
OS Version
11
Additional system information
R9-14900k 64 GB DDR5-5600
Printer
Bambu Lab X1C
How to reproduce
When using support BLOCKERS and auto support with SNUG it puts support in small areas. e.g I make small cylinder holes in my prints with diameter 2.3 or 3.3 mm and despite support blocker the slicer ignores it. And it is not only this files attached it does it.
Actual results
Soppuer are printed in places where it is not supposed to be printed
Expected results
NO support in blocked areas.
Project file & Debug log uploads
Orca SNUG error.zip
Checklist of files to include
Anything else?
No response
The text was updated successfully, but these errors were encountered: