Skip to content

Latest commit

 

History

History
73 lines (63 loc) · 4.28 KB

0_Installation.md

File metadata and controls

73 lines (63 loc) · 4.28 KB
Raw

Quick Reference Guide

Installation


Find configurations for your device:
#1 Installing your device : chapter below
#2 Using the new Edge Cockpit to start-up Settings, Node-RED, InfluxDB, Docker-portainer, ... Chapter Edge Cockpit
#3 Network and WIFI Configuration / Accessing the internet Chapter Network Configurations
#4 Using the DisplayPort to output a local Visualisation or set configurations Chapter DisplayPort
#5 Using the USB-Ports Chapter USB-Ports
#6 Change the timezone and date Chapter Time&Date

Datasheet

A datasheet can be found on the official Phoenix Contact homepage:
Link to EPC 15x2 datasheet
The datasheet is valid for both devices.

Set up your hardware

Choose the desired mounting method and follow the appropriate procedure.

Wall mount

Order No. 1147655
The EPC 15x2 can be attached to a flat surface in a wall-mount orientation using the four key holes. The mounting surface must be flat and not subject to vibration.

NOTE: The EPC 15x2 must be installed with the connectors oriented down to allow the convection cooling to function efficiently

Installation:

  1. Attach the two brackets to the EPC... using the included M3x5 screws.Torque the screws to 0.5 Nm.
  2. Use the EPC 15x2 as a template and mark the locations of the mounting holes on the mounting surface.
  3. Use the correct anchor type for the mounting surface and securely attach the EPC 15x2 to the wall. Ensure the attaching hardware is in the small section of the mounting holes.
    EPC_Wall_Mount

DIN rail mount

Order No. 1147464

  1. Install the mounting bracket on the EPC... with the included M3x5 screws so the connectors will be oriented downward after installation. Torque the screws to 0.5 Nm
  2. Angle the EPC 15x2 so the top edge of the mounting plate hangs on the top edge of the DIN rail.
  3. Rotate the EPC 15x2 down against the lower edge of the DIN rail. Press in until the latch snaps closed.
  4. Secure the device on the rail with clamps.
  5. If necessary to remove, release the latch using a screwdriver, rotate the bottom of the EPC away, and then lift it straight up off the DIN rail
    EPC_DinRail

Connecting the power supply

A removable plug (Order No. 1847055 on the EPC 15x2 accepts wire sizes of 0.2 ... 2.5 mm² (12 ... 24 AWG).

NOTE: To ensure safe operation, use safety extra-low voltage (SELV) according to DIN EN 61131 as supply voltage. This device is protection class I item of equipment.

  1. Connect the power conductors to the appropriate terminal in the connector.
  2. Connect the ground/earth to the screw (5).
  3. Insert the connector into the IPC.
    EPC_PS


Now that your EPC is installed and ready to use, see the next chapter: [Edge Cockpit](1_EdgeCockpit.md).

If you are still using Firmware 2021.0, please see [how to update to FW 2022.0](2_FirmwareUpdate.md).