You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi,
I'm trying to describe PVT properties of wet gas with small ogr using PVTG and PVTO keywords in black oil mode.
The run in OPM/Flow starts fine but a few steps after the pressure goes below Pdew the stepsize is chopped multiple times and the run is unable to finish.
In the commercial simulator I can only define the understaturated portion of the curve in PVTO, however from the OPM/Flow manual I understand that should be able to cover both saturated and undersaturated sections. When I try to define the saturated portion I get an error stating that Bo can only decrease with pressure (undersaturated portion). Am I missing anything obvious here?.
Thanks a lot,
Mariano Fernandez
The text was updated successfully, but these errors were encountered:
Hi,
I'm trying to describe PVT properties of wet gas with small ogr using PVTG and PVTO keywords in black oil mode.
The run in OPM/Flow starts fine but a few steps after the pressure goes below Pdew the stepsize is chopped multiple times and the run is unable to finish.
In the commercial simulator I can only define the understaturated portion of the curve in PVTO, however from the OPM/Flow manual I understand that should be able to cover both saturated and undersaturated sections. When I try to define the saturated portion I get an error stating that Bo can only decrease with pressure (undersaturated portion). Am I missing anything obvious here?.
Thanks a lot,
Mariano Fernandez
The text was updated successfully, but these errors were encountered: