You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When a control surface is classified as Dynamic (i.e. in the aero.h5 input file control_surface_type[i_cs] = 1), the StaticTrim routine fails because it is unable to change the control surface deflection angle.
Minor impact since you can get the trim condition with the control surface as static first (i.e. control_surface_type[i_cs] = 0) and then run the Dynamic simulation starting from StaticCoupled with the already known trim values. However, this behaviour is worth fixing.
The text was updated successfully, but these errors were encountered:
When a control surface is classified as
Dynamic
(i.e. in the aero.h5 input filecontrol_surface_type[i_cs] = 1
), theStaticTrim
routine fails because it is unable to change the control surface deflection angle.Minor impact since you can get the trim condition with the control surface as static first (i.e.
control_surface_type[i_cs] = 0
) and then run the Dynamic simulation starting fromStaticCoupled
with the already known trim values. However, this behaviour is worth fixing.The text was updated successfully, but these errors were encountered: