You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have transfered my Homematic BidCoS from FHEM to HomeGear.
I use HomeGear with a CUL and have transferred the hmid from FHEM to HomeGear.
The devices show up in HomeGear after I manually added them via peer (peer add ....).
I use homegear as a bridge for HomeAssistant. So far, so good.
I noticed that homegear does not assign a single channel to any of the connected devices.
This is not bad in most cases, except for a HM-MOD-Re-8.
This is shown as a 1 channel switch and so I could only switch port 1, as the others are not visible in either HomeAssistant or HomeGear.
Can anyone give me a hint how to assign the channels in HomeGear or how to access ports 2-8 of my HM-MOD-Re-8 in HomeAssistant?
Thx
Holly
The text was updated successfully, but these errors were encountered:
I have transfered my Homematic BidCoS from FHEM to HomeGear.
I use HomeGear with a CUL and have transferred the hmid from FHEM to HomeGear.
The devices show up in HomeGear after I manually added them via peer (peer add ....).
I use homegear as a bridge for HomeAssistant. So far, so good.
I noticed that homegear does not assign a single channel to any of the connected devices.
This is not bad in most cases, except for a HM-MOD-Re-8.
This is shown as a 1 channel switch and so I could only switch port 1, as the others are not visible in either HomeAssistant or HomeGear.
Can anyone give me a hint how to assign the channels in HomeGear or how to access ports 2-8 of my HM-MOD-Re-8 in HomeAssistant?
Thx
Holly
The text was updated successfully, but these errors were encountered: