I am having issues with key configuration while using the PXN V9 racing wheel

[agnoisa]

Is there an existing issue for this?

• I searched the existing issues and did not find anything similar.

Current Behavior

When I press the accelerator or brake pedal once, the axis value changes from 0 to a negative value and reaches the end (Image attached).

However, the clutch pedal maintains a value of 0 even after being pressed. The problem is that the axis value for the accelerator and brake pedals changes to a negative value once pressed, whereas it should remain at 0 before being pressed. I'm not sure what the issue is, but I want to ensure that the axis value stays at 0 normally

Expected Behavior

No response

Steps To Reproduce

No response

Environment

No response

Anything else?

No response

[pktiuk]

Could you open Options ->Properties window and check whether values in this place are displayed correctly?

[agnoisa]

-----Original Message----- From: "Paweł ***@***.***> To: ***@***.***>; Cc: ***@***.***>; ***@***.***>; Sent: 2023-12-03 (일) 22:17:28 (GMT+09:00) Subject: Re: [AntiMicroX/antimicrox] I am having issues with key configuration while using the PXN V9 racing wheel (Issue #878) Could you open Options ->Properties window and check whether values in this place are displayed correctly? — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread. Thank you so much for your reply. I didn't expect to receive a reply by email, so it was too late to check. I'm sorry. I am attaching two images here. A before stepping on the pedal B after pedaling The symptoms are the same. A------------ B------------------------ Message ID: ***@***.***>

[pktiuk]

Sorry, but I cannot see any images.